利用锥形束CT对下颌磨牙根分叉病变区骨嵴形态的观察

doi:10.3969/j.issn.1671-167X.2017.01.011

北京大学学报(医学版) ›› 2017, Vol. 49 ›› Issue (1): 67-070. doi: 10.3969/j.issn.1671-167X.2017.01.011

利用锥形束CT对下颌磨牙根分叉病变区骨嵴形态的观察

朱洁1,2，欧阳翔英1△

（1. 北京大学口腔医学院·口腔医院，牙周科口腔数字化医疗技术和材料国家工程实验室口腔数字医学北京市重点实验室，北京100081；2.北京大学国际医院口腔科，北京102206）

出版日期:2017-02-18 发布日期:2017-02-18
通讯作者: 欧阳翔英 E-mail:kqouyangxy@126.com

Observation of bone morphology in furcation defects of mandibular molars using cone beam computed tomography

ZHU Jie1,2,OUYANG Xiang-ying1△

(1. Department of Periodontology, Peking University School and Hospital of Stomatology & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China; 2. Department of Stomatology, Peking University International Hospital, Beijing 102206, China)

Online:2017-02-18 Published:2017-02-18
Contact: OUYANG Xiang-ying E-mail:kqouyangxy@126.com

摘要/Abstract

摘要：

目的：利用锥形束计算机体层摄影术（cone beam computed tomography, CBCT）观察下颌磨牙Ⅱ度和Ⅲ度根分叉病变区（furcation involvement, FI）近远中向的骨嵴形态和骨袋分布情况，并提出对骨嵴形态的分类方法。方法：在既存的CBCT资料中，选取存在根分叉区水平向骨缺损的下颌磨牙进行观察,共纳入81颗下颌磨牙，共计117处Ⅱ度或Ⅲ度根分叉病变。依据邻面牙槽嵴顶连线与根分叉顶下方的牙槽嵴的位置关系，将根分叉区近、远中向的骨嵴形态分为凹陷型、水平型和凸出型，其中凹陷型又按照邻面牙槽嵴顶的连线与根分叉顶的位置关系，分为亚型1（牙槽嵴顶连线位于根分叉顶冠方或同一水平）与亚型2（牙槽嵴顶连线位于根分叉顶的根方），统计各类型出现的比例，在CBCT的矢状面图像中观察骨袋的分布情况。结果：在117处Ⅱ度和Ⅲ度FI中，水平型骨嵴形态出现的比例最高（64.10%），凸出型出现的比例最低(6.84%)，凹陷型亚型1和亚型2出现的比例分别为13.68%和15.38%。有利于成骨的凹陷型亚型1的骨嵴形态，在Ⅱ度FI中出现的比例为8.96%，在Ⅲ度FI中为 20.00%；117处病损中，有31处合并骨下袋，其中29处骨下袋位于牙齿邻面，其余2处位于根分叉区,骨下袋出现的频率在凹陷型亚型1中最高。结论：利用CBCT观察下颌磨牙根分叉区近、远中向的骨嵴形态并进行分类，有利于制定正确的治疗方案，也可用于分析骨嵴形态与再生性治疗成骨效果间的关系。

关键词: 根分叉部缺损, 下颌磨牙, 骨嵴形态

Abstract:

Objective： To observe mesial-distal bone morphology in classes Ⅱ and Ⅲ furcation involvements (FI) of mandibular molars using cone beam computed tomography (CBCT), to develop a classification system of mesial-distal bone morphology of furcation defects and to observe the intrabony defects on CBCT images. Methods: Based on the existing CBCT data, the mandibular molars with horizontal bone defects in furcation area were observed. One hundred and seventeen sites of 81 mandibular molars with class Ⅱ or class Ⅲ FIclassified on CBCT images were included. The classification system of mesial-distal bone morphology of furcation defects was developed. According to the location of the line drawn from mesial to distal alveolar bone crest (AC-line) of the tooth and bone level under furcation fornix, the bone morphology was classified into three types, including concave type, flat type and protruding type. The concave type was divided into two subtypes according to the location of AC-line and furcation fornix (Fx), which were subtype 1（AC-line coronal or equal to Fx）and subtype 2 （AC-line apical to Fx).The frequency of each type was calculated and analyzed. The intrabony defects was observed on sagittal CBCT images. Results: In the 117 sites with FI, the flat type appeared with the highest rate (64.10%) and the protruding type appeared with the lowest rate (6.84%). The rates of subtype 1 and subtype 2 of concave type were 13.68% and 15.38%, respectively. The rate of subtype1 which was supposed to be beneficial for bone regeneration was 8.96% in class Ⅱ FI and 20.00% in class Ⅲ FI. Thirtyone intrabony defects were found among the 117 FI, 29 of which appeared in proximal aspect of the tooth and the left 2 appeared in furcation area. The highest frequency of the intrabony defects was found in subtype 1 of concave type. Conclusion: The classification of mesial-distal bone morphology on CBCT images may be helpful for clinicians to make accurate treatment plan before surgery and could be used in future studies to understand the influence of bone morphology on regenerative therapy for furcation defects.

Key words: Furcation defects, Mandibular molars, Bone morphology

中图分类号:

R781.4

朱洁，欧阳翔英. 利用锥形束CT对下颌磨牙根分叉病变区骨嵴形态的观察[J]. 北京大学学报(医学版), 2017, 49(1): 67-070.

ZHU Jie,OUYANG Xiang-ying. Observation of bone morphology in furcation defects of mandibular molars using cone beam computed tomography[J]. Journal of Peking University(Health Sciences), 2017, 49(1): 67-070.

参考文献

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed

本文评价

推荐阅读 10

[1]	田增民, 陈涛, Nanbert ZHONG, 李志超, 尹丰, 刘爽. 神经干细胞移植治疗遗传性小脑萎缩的临床研究（英文稿）[J]. 北京大学学报（医学版）, 2009, 41(4): 456 -458 .
[2]	郭岩, 谢铮. 用一代人时间弥合差距——健康社会决定因素理论及其国际经验[J]. 北京大学学报（医学版）, 2009, 41(2): 125 -128 .
[3]	成刚, 钱振华, 胡军. 艾滋病项目自愿咨询检测的技术效率分析[J]. 北京大学学报（医学版）, 2009, 41(2): 135 -140 .
[4]	卢恬, 朱晓辉, 柳世庆, 郑杰, 邱晓彦. 白细胞介素2促进宫颈癌细胞系HeLaS3免疫球蛋白G的表达[J]. 北京大学学报（医学版）, 2009, 41(2): 158 -161 .
[5]	袁惠燕, 张苑, 范田园. 离子交换型栓塞微球及其载平阳霉素的制备与性质研究[J]. 北京大学学报（医学版）, 2009, 41(2): 217 -220 .
[6]	徐莉, 孟焕新, 张立, 陈智滨, 冯向辉, 释栋. 侵袭性牙周炎患者血清中抗牙龈卟啉单胞菌的IgG抗体水平的研究[J]. 北京大学学报（医学版）, 2009, 41(1): 52 -55 .
[7]	董稳, 刘瑞昌, 刘克英, 关明, 杨旭东. 氯诺昔康和舒芬太尼用于颌面外科术后自控静脉镇痛的比较[J]. 北京大学学报（医学版）, 2009, 41(1): 109 -111 .
[8]	祁琨, 邓芙蓉, 郭新彪. 纳米二氧化钛颗粒对人肺成纤维细胞缝隙连接通讯的影响[J]. 北京大学学报（医学版）, 2009, 41(3): 297 -301 .
[9]	李伟军, 邢晓芳, 曲立科, 孟麟, 寿成超. PRL-3基因C104S位点突变体和CAAX缺失体的构建及表达[J]. 北京大学学报（医学版）, 2009, 41(5): 516 -520 .
[10]	丰雷, 王玉凤, 曹庆久. 哌甲酯对注意缺陷多动障碍儿童平衡功能影响的开放性研究[J]. 北京大学学报（医学版）, 2007, 39(3): 304 -309 .

利用锥形束CT对下颌磨牙根分叉病变区骨嵴形态的观察

Observation of bone morphology in furcation defects of mandibular molars using cone beam computed tomography

RICH HTML

PDF (PC)

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 7

Metrics

本文评价

推荐阅读 10

[1]	石姝雯,孟洋,焦剑,李文静,孟焕新,栾庆先,王万春. 根分叉病变患牙经牙周非手术治疗后5年失牙状况及多因素分析[J]. 北京大学学报（医学版）, 2019, 51(5): 913-918.
[2]	乔静，段晋瑜，褚祎，孙昌洲. 浓缩生长因子在下颌磨牙Ⅱ度根分叉病变再生治疗中的应用[J]. 北京大学学报(医学版), 2017, 49(1): 36-042.
[3]	乔静, 段晋瑜, 孙昌洲, 柳登高. 锥形束CT在下颌磨牙根分叉病变诊断中的准确性分析[J]. 北京大学学报（医学版）, 2014, 46(6): 975-979.
[4]	乔静, 段晋瑜, 孙昌洲, 柳登高. 锥束CT评价下颌磨牙根分叉病变再生治疗疗效[J]. 北京大学学报（医学版）, 2014, 46(5): 727-732.
[5]	朱卫东, 侯建霞, 刘凯宁, 唐晓琳, 孟焕新. 牙周手术治疗对猴Ⅲ度根分叉病变模型龈下菌斑中牙周致病微生物的影响[J]. 北京大学学报（医学版）, 2012, 44(1): 22-28.
[6]	钟金晟, 欧阳翔英, 柳登高, 曹采方. 锥形束CT测量离体下颌磨牙Ⅱ°根分叉病变效果的评价[J]. 北京大学学报（医学版）, 2010, 42(1): 41-45.
[7]	朱卫东, 侯建霞, 刘凯宁, 孟焕新, 唐晓琳. 自体牙周膜细胞和釉基质蛋白修复猴下后牙Ⅲ度根分叉病变[J]. 北京大学学报（医学版）, 2009, 41(1): 56-61.