Abstract: Objective: To evaluate effects of color matching of different cavosurface margins on the resin composites in vitro.Methods: Twenty extracted human premolars with an A2 shade buccal surface were used in this study. Rectangular shaped cavities (3.0 mm depth, 2.0 mm width, 2.0 mm length) were prepared in the center of the buccal surfaces. The gingival and occlusal cavosurface margins were prepared to be either shoulder or bevel; the other cavosurface margins remained vertical. Ten teeth were filled with Clearfil AP-X (AP), the other ten with Clearfil Majesty (MJ) and light cured. The color difference at the cavosurface margin area was measured using a spectrophotometer (CrystalEye) and evaluated by 3 observers subjectively. The data were statistically analyzed using repeated measures ANOVA and Chi-square test. Results: When measured by CrystalEye, the color difference between the tooth and resin composite was reduced from the center of restoration to the cavosurface margin area. Both objective and subjective evaluations showed that for AP, the color difference at the cavosurface margin area had no statistical difference among 3 types of the margins; for MJ, the color difference at bevel margin area was significantly smaller than that at the vertical margin area. Conclusion: The resin composite restorations produced the color matching at marginal area. The color matching of resin composites with higher diffused light transmission property is more susceptible to the type of cavosurface margins. Preparing bevels may reduce the color difference between the restoration and tooth surface.

Key words: Dental cavity preparation, Composite resins, Color